Advertisement
Installation Instructions
[] CONNECT THE WATER LINE
• Make sure there is enough plastic water line to
extend from the water valve to well into the water
tube inlet (15). Cut off any excess tubing.
• Squeeze the ends of the hose clamp (3) or (6)
from the kit with pliers and slide the clamp over
the water robe inlet. (Use the black clamp (3) with
the black water tube inlet, use the other clamp (6)
with the other water tube inlet.)
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1" [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water tube
inlet
®or®
[] ROUTE AND ATTACH THE
PLASTIC WATER LINE
• Route the plastic water line along the back of the
refrigerator
to the water tube inlet.
• Use the three
adhesive
backed
fasteners
(5) to
secure
the plastic water line to the case back.
/
Adhesive-backed
fasteners
forplastic w ater l ine
[]WATER
VALVE INSTALLED
Refer to the Water Line Installation
Instructions
for connection
to the home water supply. After
water line installation
is completed,
set the
icemaker
power switch to I (on).
The icemaking cycle will not begin until the iconaher
and ffeezer compartment
reach operating temperature,
then icemaking will begin automatically.
33
Advertisement
