Advertisement
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS []
Are these
the right
instructions
for your model?
Follow
the Installation
Instructions
indicated
by
the label
on the back of the refrigerator--
[]
[]
[] []
[]
[]
[] [] []
[]
[]
[] or []
BEFORE YOU BEGIN
Read each step thoroughly
before proceeding.
• CAUTION
-
Unphtg
the
Refrigerator.
To eliminate
the danger
rr,
of electric
shock during installation,
_
[_
you must unplug
the refrigerator
_
fi-om its electrical
oudet.
TOOLS YOU WILL NEED
FlatbladeandPhillips
Pliers
scrawdtivers
Sharpknife
1/4"and5/16" Nutdriveror adjustable wrench
[] REMOVE ICE CUBE TRAY SHELF
If your refrigerator
has an installed
ice cube tray
shelf, use a Phillips
screwdriver
to remove
the two
screws. Remove
the ice tray shelf. Install the
screws in the back two holes until the screw heads
are about
1/2"
(13 mm) from the side wall of the
freezer.
If your refrigerator
was not originally
equipped
with an installed
ice cube tray shelf,
use the screws (14) that are supplied
in the kit.
Place the shelf, flat side up, in the lower basket
with the sloped
end at the back.
Partially r einstall two
Remove sticker
screws i nrear t w_o
_
[] PREPARE THE REFRIGERATOR
Find the sticker located
on the back of the
refrigerator
about
midway up on the right
/ Remove sticker
hand
side. Remove
the
sticker
and clear away
o_
any foil tape from the
9
opening.
Also remove
the sticker from the top
Remov_
left corner
of the
insulation p lug
freezer
compartment.
Remove
the gray insulation
plug that fills the hole
through
the cabinet.
[] INSTALL FILL TUBE
• Cut the Fill tube (16) to the []
length
(refer to the [_ template
(_'_111_
_
on page 66) with a sharp
knife
or a single-edge
razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15 ).
• Cut the fill tube extension
(10) to the []
length
(refer to the []
template
on page 67) with a
sharp
knife or a single-edge
razor blade.
• Slide the Fill tube extension
(10) completely
over
the fill tube on the water tube inlet (15).
• On the tube side of the water
tube inlet (15) there
is an
O
adhesive
backing.
Remove
the
backing
and slide the tube into
the hole on the back of the
refrigerator
as shown. Firmly
press on the inlet to secure it.
[] SET POWER SWITCH
TO O (off)
Set the icemaker power switch to 0 (off). Leave
the power switch in the 0 (off) position
until the
refrigerator
is connected
to the water supply to
prevent premature
operation.
Po_er
Switch
wireRe
26
Advertisement
