Changing the low cutoff value
The following is an example to show how to change the low cutoff value from 1.0% to 3.0%.
Switch operation
D2: LOW CUT
D2: LOW CUT
D2: LOW CUT
D2: LOW CUT
D2: LOW CUT
Note: If you try to set a value exceeding 10.0%, *H. OVER SPEC.* appears and the value returns to
the previously set value. In that case, try to set a new value again.
Display example
Select D2: LOW CUT from the setting item selection menu.
The currently set low cutoff value (1.0 % in this example)
01.0 %
appears.
The cursor appears.
Press
01.0 %
change.
Change the number of the digit.
To change another digit, press
03.0%
the cursor to that digit and change the number there.
The display brinks and the set value is displayed for
confirmation.
Press
03.0 %
disappears and the display returns to the condition that the
setting value is displayed.
Returns to the menu of setting item selection.
- 82 -
Description
further to move the cursor to the desired digit to
again to write the data. Then the cursor
MENU/ENT
6F8A0917
under this condition to move