Changing the damping constant
The following is an example to show how to change the damping constant from 0.5 sec to 10 sec.
Switch operation
D1: DAMPING
D1: DAMPING
D1: DAMPING
D1: DAMPING
D1: DAMPING
Note: If you set a value exceeding max value, it is forcibly changed to max value before data is
written.
Display example
Select D1: DAMPING from the setting item selection menu.
The currently set damping constant (0.5 s in this example)
00.5 s
appears.
The cursor appears.
Press
00.5 s
change.
Change the number of the digit.
10.5 s
To change other digit, press
the cursor to that digit and change the number these.
10.0 s
The display blinks and the set value is displayed for
confirmation.
Press
10.0 s
disappears and the display returns to the condition that the
setting value is displayed.
Returns to the menu of setting item selection.
- 80 -
Description
further to move the cursor to the desired digit to
again to write the data. Then the cursor
MENU/ENT
6F8A0917
under this condition to move