GE Quick Set V Series Owner's Manual page 46

Before You Call For Service...
Troubleshooting Tips
Clock and timer do
not work
Oven will not self-clean
"Crackling" or
"popping" sound
Excessive smoking
during a clean cycle
Oven door will not
open after a clean cycle
Oven not clean after a
clean cycle
"LOCKED" flashes
in the display
"LOCKED" is on
when you want
to cook
"F--" and a number
or letter flash
in the display
Possible Causes What To Do
Plug on ronge is not completely • Hake sure electrical plug is plugged into a live, properly
inserted in the electricol outlet, grounded outlet.
A fuse in your home
may be blown or the
circuit breaker tripped.
• Replacethe fuse or reset the circuit breaker.
Oven controls improperly set. • See the Using the kitchen timer section.
The oven temperature is
too high to set a self-clean
operotion.
• Allow the range to cool and reset the controls.
Oven controls improperly set. • See the Using the self-cleaning upper and lower ovens
section.
The probe is plugged into
the outlet in the oven.
(on some models]
• Remove the probe from the oven.
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
• This is normal.
Excessive soil.
• Touch the CLEAR/OFFpad. Open the windows to
rid the room of smoke. Wait until LOCKED/DOOR
goes off. After the oven cools, wipe up the
excess soil and reset the clean cycle.
Oven too hot.
• Allow the oven to cool below locking temperature.
Oven controls not properly set. • See the Using the self-cleaning upper and lower ovens
section.
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
The self-clean cycle has been • Close the oven door.
selected but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
• Touch the CLEAR/OFF
pad.
Allow the oven to cool.
You have a function error code. • Disconnect all power to the range for at least
30 seconds and then reconnect power. If the function
error code repeats, call for service.
46