GE Quick Set V Series Owner's Manual page 16

Using the oven.
To avoid possible burns, place the racks in the desired position before you turn on the oven.
%
ZJ
Before you begin...
Therackshave stops,sothat when placed
correctly on the supports,they will stop before
coming completely out and will not tilt
When placing and removing cookware, pull the
rack out until it stops.
On some models,the bake heating element
is under the oven floor. Never place cooking
utensils, baking stones, foil, or any other items
on the oven floor.
The number of rack positions may
vary by model.
v" V
Never place cooking utensils, baking stones,
foil, or any other items on the oven floor.
To remove a rack, pull it toward you, tilt the
front end up and pull it out.
To replace, place the end of the rack (stop-
locks)on the support, tilt up the front and push
the rack in.When you are usinga rack in the
I CAUTIONI
lowestposition(A), you will need to usecaution
when pulling the rackout. We recommendthat you
pull the rack out severalinchesand then, usingtwo
pot holders, p ull the rack out by holding thesides
of it. Therack is low and you couldbe burned ifyou
placeyour hand in themiddle of therack and pull
all the way out. Be verycarefulnot to bumyour
hand on the door when usingthe rack in the lowest
position(A).
Front
Rail
Fully Open Position
16
Extension Rack
When placing and removing cookware,
always pull the rack out by its upper front
rail to its fully open position.
Do not extend the rack quickly. Food may
slide off the front of the rack.
To remove the rack:
E_] Make sure the rack is pushed all the way
_ntothe oven so that side paddles on the
rack from disengaged with oven support.
[] Slide the rack toward you to the bump
(stop position) on the rack support.
[] Firmly grasp both sides of the rack frame
and the sliding rack, tilt the front end up
and pull it out.
NOTE: When handling the extension rack, do
not allow the sliding portion to fall open. This
can damage the slides.
To replace the rack:
F-_ Firmly grasp both sides of the rack
frame and the sliding rack.
Placethe curved end of the rack (stop-
locks)onto the oven supports, tilt up the
front of the rack and push it in as far as it
will go.
IACAUTION
Never use the rack when its frame is not fully
inserted in the oven and locked into position.
When the rack is properly installed and
locked into position, the locking side paddles
on the rack frame will click-lock into place
on the oven supports. If the side paddles
did not click-lock into position, repeat the
steps above and make sure the side paddles
have been correctly cleaned and lubricated.
See ExtensionRackin the Careand cleaning
section.