HP D5970A - NetServer - LCII Installation Manual page 63

Chapter 5
CAUTION Ensure you use SDRAM and not EDO DIMMs. The HP
NetServer LXr 8000 DIMMs are not compatible with the HP
NetServer LXr 8500 DIMMs.
Use only SDRAM DIMMs acquired from HP. Contact HP
Customer Support for a list of qualified DIMMs. HP will not
support configurations using non-HP Buffered SDRAM
DIMMs.
12. Locate the desired slot for installing the DIMM.
Refer to Figure 5-2 and the "Memory Guidelines" earlier in this chapter for
possible DIMM locations.
13. Remove the DIMM from its container, handling the module by its edges.
See Figure 5-5.
NOTE
Some of HP's DIMMs will not have the metal shield on the
DIMM.
14. If necessary, lay the DIMM on an anti-static surface.
15. Spread the slot's two retaining clips outward. See Figure 5-6.
Metal Shield
over Memory Chips
Figure 5-5. DIMM Module
Installing Additional Memory
55