HP D5970A - NetServer - LCII Installation Manual page 108

Chapter 8
10. Press in the release latches on each slide, and push the HP NetServer all
the way into the rack.
The flanges on each side of the HP NetServer's front edge must rest firmly
against the two front rack columns. See Figure 8-10.
Figure 8-10. Pressing in the Release Latches
11. Verify the HP NetServer slides all the way into the rack, before continuing
with the procedure.
CAUTION
To prevent a possible system crash when performing a Power
Supply Hot Swap, do not use older power supplies from the
HP NetServer LXr 8000. Use HP NetServer LXr 8500 part
number 0950-3663 (all revisions), or HP NetServer LXr 8000
part number 0950-2881, revisions 01, 02, or greater.
100
Rack Mounting the HP NetServer
Press in the release latch on
each slide and push the HP
NetServer into the rack.
Flanges