Clearing Cmos - HP D5970A - NetServer - LCII Installation Manual

Chapter 10
1. ATAPI CD-ROM Drive
2. Removable Devices
3. Hard Drive
The list provides the current boot order of the HP NetServer's internal
mass storage devices. In this list, Removable Devices refers to the HP
NetServer's flexible disk drive.
4. To change the order, use the up- and down-arrow keys to select one of the
devices.
5. Use the plus (+) or minus (-) keys to move the device up or down the list.
6. Press Esc to exit the Boot Device Priority menu.
7. To change the hard driver boot order, scroll to Hard Drive and press Enter.
Refer to Hard Drive Multi-Boot Support in Information Assistant on the
HP NetServer Online Documentation CD-ROM under Configure for more
information.
8. Use the plus (+) key to move the desired hard drive (or DAC) to the top of
the list.
NOTE If Multi-boot is Enabled (default setting) and you want the HP
NetServer to boot from a specific hard drive, you must select
the specific hard drive from the list to ensure the HP NetServer
will boot from the desired hard drive.
9. Press Esc to exit the Hard Drive menu.
10. Press Esc again to exit the Boot menu.
11. Use the right- or left-arrow keys to select the Exit menu.
12. Choose Exit Saving Changes from the list of exit options, then press
Enter.
A dialog appears asking you to confirm your decision.
13. Choose Yes and press Enter.
The HP NetServer then reboots.

Clearing CMOS

To clear CMOS from within the setup utility, refer to the following procedure.
1. Start the setup utility.
Configuring the HP NetServer
125