Tools Required; Hp Netserver Rack Mount Parts List - HP D5970A - NetServer - LCII Installation Manual

Chapter 13
NetServer's fans will only operate correctly if both front and rear doors of
the rack allow free air flow (perforated openings), or are removed.
Mechanical Loading - Uneven mechanical loading within the rack can
cause hazardous conditions. To prevent this in your installation plans,
place the heaviest components in the bottom of the rack, mounting all
components as low in the rack as is practical.
Circuit Overloading - Ensure the total configuration of equipment in the
rack does not overload the supply circuit. To this end, check the nameplate
ratings on all equipment. Consider the effect of circuit overloading on
overcurrent protection and supply wiring.
Reliable Earth Grounding - Maintain reliable grounding of rackmounted
equipment. Give particular attention to supply connections not directly
connected to the branch circuit: such as, using non-HP power strips.

Tools Required

You need these tools to mount the HP NetServer in the rack:
Nut driver or wrench
T-15, T-20, and T-25 Torx
Number 2 Phillips screwdriver
Marking pen

HP NetServer Rack Mount Parts List

Ensure the rack-mounting kit provided with the HP NetServer contains the
following parts:
Table 13-1. Parts for Rack Mount Kit
Quantity
2 Slides
4 Rack Nuts
4 Rack Nut Screws (M5 x 16mm)
8 Screws for Slides (8-32 x ¼ inch)
1 Template
®
Drivers
Description
Alternative Rack Mounting
151