HP D5970A - NetServer - LCII Installation Manual page 162

Chapter 13
Brackets
Figure 13-3. Removing the Slides' Mounting Flanges
2. Pull the anti-tip foot forward out of the bottom of the rack.
3. Hold the template alongside the inside face (side) of the left-front rack
column.
4. Line up the template with the bottom line of the rack space the HP
NetServer will occupy.
The template covers a span of 7 EIA units, which is the height requirement
of the HP NetServer.
5. Mark the single hole indicated by the template for future reference.
The template directs you to a single hole in the rack column used for
mounting the slide.
6. If you don't have the template, use the markings shown in Figure 13-4 to
determine which hole on the column the slide mounts through.
154
Alternative Rack Mounting
Slide