Changing The System Date And Time - HP D5970A - NetServer - LCII Installation Manual

Chapter 10
NOTE To leave the dialog without entering a password, press the Esc
key at any time.
6. In the Confirm New Password field, type the password again and then
press the Enter key.
7. Select the Exit menu by using the right-arrow or left-arrow key.
8. Choose Exit Saving Changes from the list of exit options, and then press
Enter.
A dialog appears and asks you to confirm your decision.
9. Choose Yes and press the Enter key.
The HP NetServer then reboots.
10. To change one of the passwords at a later date, return to the Security menu
and repeat Step 4 through 9, above, for one or both passwords.
NOTE The HP NetServer Utilities provide a selection to allow the
user to reset their password, if they have forgotten it. The
selection is titled RMC User Password Reset.
This can also be done by toggling a switch, position 6 in the
Configuration Switch Block on the I/O baseboard.

Changing the System Date and Time

To change the HP NetServer date and time, refer to the following procedure.
1. Use the right-arrow or left-arrow key to select Main from the Setup menu.
As soon as you do this, the main setup screen appears.
2. Use the down-arrow key to move to the System Time field.
This field actually consists of three fields: hours, minutes, and seconds.
3. Type in the hour in the hours field and press Enter to move to the
minutes field.
4. Type in the minute in the minutes field and press Enter again to move to
the seconds' field.
5. Type in the second in the seconds field and press Enter.
6. Leave this field using the arrow keys.
Configuring the HP NetServer
123