HP D5970A - NetServer - LCII Installation Manual page 113

Chapter 8
6. At the front of the rack, insert the screws through the flanges into the rack
nuts and secure the HP NetServer to the front rack columns with a Torx
T-25 driver.
Each of the HP NetServer's two front flanges has two slots, which should
line up with the rack nuts previously mounted on the rack columns.
7. Hold the bezel in front of the HP NetServer and line it up with the hinge
and bezel latch.
8. Press it firmly into place, especially at the top-left and bottom-left corners.
You should hear several clicks as the bezel snaps into place on the hinge
and latch. See Figure 8-16.
Figure 8-15. Attaching the Bezel Latch
Rack Mounting the HP NetServer
®
105