HP D5970A - NetServer - LCII Installation Manual page 106

Chapter 8
WARNING
To prevent the rack from rolling while you mount the HP
NetServer, ensure the leveler screws on the rack's lower four
corners are in firm contact with the floor.
3. With the help of at least one other person, lift the HP NetServer by its four
handles off the floor or pallet.
4. Move the HP NetServer between the extended slide members to position
the slides underneath the HP NetServer's handles on each side.
See Figure 8-8.
2. Fasten slides to
NetServer with screws
(four screws per slide).
Figure 8-8. Mounting the HP NetServer on the Slides
5. Lower the HP NetServer onto the slide members. See Figure 8-8.
98
Rack Mounting the HP NetServer
1. Move NetServer
onto slides.
Handles