Rack Installation; Removing The Power Supplies - HP D5970A - NetServer - LCII Installation Manual

Chapter 13

Rack Installation

This section describes removing the power supplies and installing the HP
NetServer into the rack.

Removing the Power Supplies

1. Before lifting the HP NetServer, you must remove all three power supply
modules to reduce the HP NetServers weight for lifting.
2. Pull down on the black handle on each module.
3. Then pull the module out of the HP NetServer. See Figure 13-6.
WARNING
Removing the power supplies reduces the HP NetServer's
weight (155 lbs.) significantly and reduces the likelihood of
accidents. Re-install the power supplies only after the HP
NetServer is securely mounted. Failure to observe this
warning could result in serious injury to you or damage to the
HP NetServer.
Figure 13-6. Removing the Power Supply Modules
Alternative Rack Mounting
157