HP Integrity rx4610 User Manual page 94

Chapter 8
12. Remove all DC-DC converters from the Sideplane.
Figure 8-2. Removing the Sideplane DC-DC Converters
13. Loosen the two captive screws that hold the plastic shield over the I/O
Baseboard. These screws also secure the baseboard tray to the server
chassis.
14. Remove the PCI LED cable.
15. Remove the plastic shield.
16. Remove the Internal SCSI cable for the hard drives from the board.
17. Use the two extraction/installation levers on the sides of the I/O Baseboard
to pull it clear of the connector on the Sideplane.
18. Once loose, slide the I/O Baseboard in the direction of the levers against
the chassis frame.
86
Server Management Boards