HP Integrity rx4610 User Manual page 125

Chapter 10
Advanced Configuration Power Interface (ACPI) Setup
ACPI Setup provides the ability to configure the ACPI features described below:
ACPI Feature
Button Model
State Notify
Fan Control
Platform Event Filtering (PEF) Setup
Platform Event Filtering is used to configure the actions taken when certain
platform events occur. You must select <Save> in the PEF Setup page to actually
set the filter entries.
The available event filters are:
PEF Feature
PEF Enable
Logging Enable
PEP Actions
Power Down
Sets the power and/or sleep button model used by the
system:
•
Power Button Only. The system supports a
single power button.
•
Power and Sleep Buttons. The system
supports both power and sleep buttons.
Specifies whether other server management
controllers in the system will be notified upon
ACPI power state changes:
•
Enable. Enables notification.
•
Disabled. Disables notification.
Controls fan operation when the system enters the S1
sleep state:
•
Do Not Stop Fans. Fans continue to run when
the system enters a sleep state.
•
Stop Fans. Stops fans on a sleep state.
Description
Enables or disables Platform Event Filter (PEF).
Enables or disables system event logging when an event
filter is triggered.
Enables or disables Platform Event Paging (PEP) actions
when an event filter is triggered. PEP sends a phone page
when an event triggers the filter.
Enables or disables system power down when an event
filter is triggered.
Configuring the HP Server
Description
117