HP Integrity rx4610 User Manual page 161

Chapter 10
Displaying Usage Information
When the utility is invoked with the /? or /h command line arguments, the
following message is displayed.
FRU & SDR Load Utility for EFI Version 1.0
Usage: FRUSDR
/? or /h
/d { fru,sdr}
/Cfg filename.cfg
/p
This utility is used to program, compare, or display FRU and/or SDR information.
It must be run on the rx4610 system executing NSHELL under the EFI
environment. Upon completing the programming of the FRU and/or SDR areas,
the server should be rebooted.
NOTE
The /p argument is not supported in conjunction with an INI
file.
The /D FRU command displays the contents of a FRU. Any additional
arguments specify the Address of the FRU to be displayed. If no Address is
specified, the BMC FRU is displayed. The arguments that make up the Address
are the NVS_TYPE, DEV_CNTR, and DEV_ID -- which can be found in the
FRU file header of each FRU file. Arguments must be specified in the order
listed. If DEV_CNTR is specified it must start with C. If DEV_CNTR is not
specified it defaults to C20.
Usage:
FRUSDR /D FRU [(NVS_TYPE) [DEV_CNTR] (DEV_ID
Examples:
FRUSDR /D FRU IMBDEVICE CCO 01
FRUSDR /D FRU IMBDEVICE C20 0D
FRUSDR /D FRU IMBDEVICE 10
FRUSDR /D FRU
The configuration file may be used to load multiple FRU and SDR files. In the
configuration file, each FRU and SDR file name must be called out. Additionally,
each FRU area and field to be programmed must also be specified. The
configuration file may be used to prompt or request information from the user, and
to inquire from the user which FRU areas to program.
Displays usage information.
Only displays requested area.
Uses custom CFG file.
Pause between blocks of data.
{for Hot-Swap Back Plane}
{for Processor Board}
{for I/O BaseBoard}
{for BMC (Legacy Board)}
Configuring the HP Server
)
153