HP Integrity rx4610 User Manual page 43

Chapter 4
3. Disconnect the drive's data and power cables from the drive cable adapter
PCB at the rear of the drive.
4. Loosen the thumbscrew found at the rear of the drive carrier assembly.
5. Slide the drive and drive carrier assembly towards the rear of the chassis so
that the front part of the drive clears the opening in the chassis.
6. Place the drive in an antistatic protective wrapper if you are not reinstalling
the same drive.
Installing the DVD Drive
To install the new DVD drive, complete the following steps:
1. Remove the new drive from its protective wrapper, and place it face down
on an antistatic surface.
2. Record the drive model and serial numbers in your equipment log.
3. Pick up the DVD drive and drive carrier assembly and place it face up
(carrier side down) on the chassis such that the front of the drive is aligned
with the opening in the front of the chassis.
Installing Mass Storage Devices
Figure 4-4. Installing the DVD
35