HP Integrity rx4610 User Manual page 159

Chapter 10
4. Run the utility by entering a frusdr command based on the following
syntax:
frusdr [option] [/p]
The frusdr command accepts single options only. You can accompany any
option with the /p switch to cause the output to pause between blocks of
displayed output. For descriptions of the FRUSDR Load Utility
command-line options, see Table 10-19.
NOTE You can run the utility directly from the configuration software
CD-ROM or from diskettes you create from the CD-ROM
included with the system. If you choose to run the FRUSDR
Load Utility from a diskette, you must copy the utility from the
CD-ROM and follow the instructions in the included
README.TXT file.
5. Use the FRUSDR Load Utility to manage server management subsystem's
product level FRU and SDR repository.
6. Reboot the system by powering off and powering on the server. The
reboot operation is necessary because the firmware must reload to properly
initialize the sensors after programming and thus effect the changes you
have made to the FRU and SDR repository.
FRUSDR Load Utility Command-line Options
The Load Utility uses command line precedence. This means that the first
command found is operated on, followed by the next command, and so on.
Commands can be broken up into two categories: Flag Commands and Action
Commands. The only Flag Command is the Pause (/p) flag command. This flag
is then used by the Action Commands. The Action Commands are: /?, /d, and
/Cfg.
The pause command only affects the execution path of certain Action Commands.
For example, the Pause flag command only provides additional information when
used with the help and display FRU and SDR action commands.
If an Action Command does not use the Pause Flag, no error is displayed. It was
felt that this is a minor error and should not prevent the utility from functioning.
If more than one Action Command is listed on the command line, then an error is
displayed and the utility exits. The error that is displayed will depend on what the
command was. Table 10-19 describes the command-line options for the FRUSDR
Load Utility. You can precede each option with either the forward slash character
(/) or the hyphen character (-).
Configuring the HP Server
151