Powering On Loads - Huawei FusionPower6000 UPS5000-H-600 kVA-FT User Manual

UPS5000-H-600 kVA-FT(M)
User Manual (FusionPower6000)
Starting the Inverter on the WebUI
Step 1 Open a browser (Chrome, Firefox, or Edge are supported). Take Edge as an
example. Choose Settings > Default browser and set Allow sites to be reloaded
in Internet Explorer mode (IE mode) to Allow.
Step 2 Choose More tools > Internet options, click the Advanced tab, check that Use
TLS 1.2 and Use TLS 1.3 are selected, and click OK.
Step 3 In the address box of the browser, enter https://
Step 4 Enter the correct user name and password and click Login.
Step 5 On the WebUI, choose Monitoring > UPS System > Running Control, click Inv.
ON, and confirm the operation to start the inverter.
----End

5.5 Powering On Loads

Context
After the inverter starts, the UPS transfers to inverter mode, and the Bypass mode
alarm on the MDU disappears.
Procedure
Step 1 After confirming that the battery string is properly connected, turn on the battery
string input switch. If there are multiple battery strings, turn on the switch for
each battery string and then the general switch between the battery strings and
the UPS. The No battery alarm on the MDU disappears.
Step 2 Turn on the downstream output switch to supply power to loads.
----End
Issue 02 (2024-01-05)
NO TE
If the power module receives a startup command when it cannot be started, the startup
command will be retained for 1 minute. Within 1 minute, if there is no situation (for
example, the power module encounters other faults, executes a shutdown command, or
performs fault clearance) that requires the startup command to be cleared and the power
module becomes able to start, then the power module responds to the startup command.
Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Single UPS Commissioning
UPS IP address .
85