ABB SM2000 User Manual page 17

...2.6 Process View
Configuration
Set up
View select
Alarms
Statistics
Operator messages
Message 1
Duty/Stby Switched
Message 3
Message 6
<User defined>
Totalizer stop/go
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Stop
Ch 1.5 Temp
Go
Ch 1.6 Alarm 1
All
Totalizer reset
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Ch 1.5 Temp
Ch 1.6 Alarm 1
Alarm acknowledge
Ch 1.1 Level
Ch 1.2 Pressure
Ch 1.3 In Flow
Ch 1.4 Out Flow
Ch 1.5 Temp
Ch 1.6 Alarm 1
All
Select the Configuration level – see Section 4.
Select the Set Up level – see Section 3.
Switch between the Alarm View and Statistics View.
Note. If a channel's totalizer has not been enabled in the Configuration level, Alarm
trip levels are shown in place of the channels statistics. If no alarms are enabled, the
channel long tag is displayed for that channel.
Add one of six preset messages or a user-defined message to the alarm event log. The
selected message is displayed on screen briefly. The preset messages are set in the
Configuration level – see Section 4.
Note. Selecting the '<User-defined>' option causes a keyboard to be displayed
(see Fig 4.5) on which a message of up to 20 characters can be created.
Stop and start individual totalizers.
Note. Channel totalizers that have not been enabled in the Configuration level are
shown greyed out.
Note. When a totalizer is not running (i.e. Stop is selected), the corresponding
totalizer value is shown in red.
Reset the totalizer value to the totalizer preset value.
Note. Channel totalizers that have not been enabled in the Configuration level are
shown greyed out.
Acknowledge active alarms in the current process group, either individually or globally.
Note. Active alarms are identified by a flashing red 'Alarm Status' icon in the bottom
left hand corner of the associated channel indicator – see Fig. 2.6.
If neither alarm on a particular channel is configured, the channel short tag is greyed out in
the menu.
2 OPERATION...
15