Epson C Series Manual page 92

C4 Manipulator 6. Options
Installation example
Screws
Table Top mounting
Ceiling mounting
76
Size
A M8
B M10
The base side plate has a M10 screw hole. You can secure the plate with
NOTE

a M10 screw or a M8 screw by using a prepared screw hole of ø8.5 to make
a M8 screw hole on the mounting surface.
A: Securing from above
NOTE

To secure from above, use the screw A in the table above.
When you install the Manipulator for practical use, you need to insert the
screws in the right/left side from the same direction (above or below).
B: Secures
from below
A: Secures
from below
Recommended length
30 mm or more
15 mm + Base Plate or more
A: Secures
from above
A: Secures
from below
B: Secures
from above
B: Secures
from below
B: Secures
from above
← Base Plate
(Floor)
A: Secures
from above
← Base plate
(Ceiling)
C series Rev.2