Canon imagePRESS Server G200 Service Manual page 48

• Fiery USB Setup Tool DVD (provided with the imagePRESS Server media pack)
• System Software DVD, or an ISO image file for the system software (provided with the imagePRESS Server, the option kit,
or the spare kit)
• User Software DVD (provided with the imagePRESS Server media pack)
• USB 2.0/3.0 flash drive (not provided). If the drive has a write-protection feature, make sure that write-protection is switched
off.
The drive must have a minimum capacity of 8GB and maximum capacity can be up to 32GB. The limit of 32GB maximum
capacity is due to compatibility with FAT32 file system.
Not all USB 2.0 flash drives have been validated for use with the imagePRESS Server. If the drive that you are using does
not work, try another brand.
• Any computer (not provided) with:
• Windows 7, Windows 8.1, or Windows 10.
• DVD drive, built-in or attached
A DVD drive is not required if the system software is provided as an ISO file.
• Support for USB 2.0 or USB 3.0 (USB 1.1 may work, but it will be very slow.)
• Minimum of 500MB of available memory
The procedures in this section are:
• "To install the Fiery USB Setup Tool application" on page 43
• "To copy software to a USB flash drive" on page 43
• "To install system software using a prepared USB flash drive" on page 44
■ To install the Fiery USB Setup Tool application
1. Insert the Fiery USB Setup Tool DVD into the media drive of the computer.
2. Double-click the executable file (the file type is Application) located on the root directory of the DVD to start the installer.
3. At the Welcome screen click Next.
4. Accept the terms of the license agreement and then click Next.
Wait while the installer verifies the installation requirements.
NOTE:
If the computer does not already have .Net framework installed, click Accept to accept the terms of the license agreement that
appears on the screen. Wait up to 10 minutes as the .Net framework files are installed.
5. At the next screen, accept or change the destination location, and then click Install.
6. When prompted, click Install to begin the installation.
Wait while the application is installed on the computer.
7. At the InstallShield Wizard Complete screen, click Finish.
8. Remove the Fiery USB Setup Tool DVD.
■ To copy software to a USB flash drive
NOTE:
This procedure uses the Fiery USB Setup Tool application to copy the software to the USB flash drive.
1. If necessary, start the Fiery USB Setup Tool application by clicking Start on the Windows computer and choosing All Programs
> EFI > Fiery USB Setup Tool.
2. Attach the USB flash drive to the Windows computer.
IMPORTANT:
All data on the USB flash drive is lost when the drive is reformatted during the preparation procedure. Make sure that
no valuable data resides on the USB flash drive.
3. Depending on the file format of the system software provided, do one of the followings:
• If the system and user software are provided as ISO image files, drag and drop the ISO image files onto the Fiery USB
Setup Tool window.
• If the system and user software are provided as DVD media, insert the System Software DVD into the DVD drive, drag
and drop the DVD drive (for example, d:) onto the Fiery USB Setup Tool window.
• When prompted to insert another media into the DVD drive, remove the System Software DVD and insert the User
Software DVD in the media drive. Drag and drop the DVD drive icon onto the Fiery USB Setup Tool window.
• Once you have copied the contents, remove the DVD from the media drive.
4. INSTALLING SYSTEM SOFTWARE
43