Canon imagePRESS Server G200 Service Manual page 21

IMPORTANT:
Be sure to use an ESD grounding wrist strap and follow standard ESD (electrostatic discharge) precautions while performing
these procedures. For details, see "Precautions" on
NOTE:
There may be tie-wraps used to secure the cables to the chassis. If necessary, cut these tie-wraps before removing the
components.
■ Printer interface board
The printer interface board is installed in PCIE x16 on the motherboard.
1
No.
1 Printer interface cable connector
2 PCIE x16 connector
3 J351 connector for 10-pin power button cable to motherboard J11
● To remove the printer interface board
1. Access and open the imagePRESS Server, as described on
2. Remove the 10-pin power button cable from J351 connector that connects between the printer interface board and the
motherboard.
3. Remove the mounting screw that secures the printer interface board to the imagePRESS Server chassis (see Figure below ).
Set aside the mounting screw so that you can replace it later.
No.
1 Mounting screw
"Precautions " on page
2
Detail of printer interface board (component side)
Removing the printer interface board
16
3.
Item
"Accessing the imagePRESS Server" on page
1
Item
3. REPLACING PARTS
3
13.