Canon imagePRESS Server G200 Service Manual page 36

■ To remove the power supply and power switch
1. Access and open the imagePRESS Server, as described on
2. Remove the 24-pin power cable from the motherboard (see
3. Remove the 4-pin power cable from the motherboard (see
4. Remove the power cable from the power connector on the HDD (see
5. Remove the power supply cables from the plastic clips that secure them to the chassis.
6. Remove the four screws that attach the power supply to the chassis (see below figure).
First remove the two screws that attach the power supply duct to the chassis. Remove the remaining two screws. Set the
screws aside so that you can replace them later.
7. Gently lift the power supply out of the chassis.
No.
1 Power switch
2 Screw (1 of 4)
■ To replace the power supply
1. If you are replacing the power switch, locate the new power switch included with the replacement power supply kit. Orient
the power switch as shown in
2. Place the power supply inside the chassis (see
Make sure to fit the power connector through the cutout in the chassis. Align the mounting holes in the power supply with
the holes in the chassis.
3. Using the four screws that you removed earlier, secure the power supply to the chassis.
Attach the power supply duct using the two screws that you removed earlier.
4. Connect the HDD power cable to the SATA power connector on the HDD.
5. Connect the 4-pin (2x2) power cable to the 4-pin connector on the motherboard.
For the location of the motherboard connector, see
through 4 of the motherboard connector. The cable is keyed to fit only one way.
6. Connect the 24-pin power cable to the 24-pin connector on the motherboard.
For the location of the motherboard connector, see
way.
7. Make sure that all power connectors are properly aligned and securely connected.
8. Secure the power cables to the chassis using the two plastic clips on the base of the chassis.
9. Replace any tie-wraps that you may have removed or cut while removing the power cables earlier.
Removing the power supply
"To remove the power supply and power switch" on page
"To remove the power supply and power switch" on page
"Motherboard jumpers" on page
"Motherboard jumpers" on page
"Accessing the imagePRESS Server" on page
"Motherboard jumpers" on page
"Motherboard jumpers" on page
"Hard disk drive (HDD)" on page
Item
31
3. REPLACING PARTS
13.
19).
19).
32).
1
2
31.
31).
19. Connect the power cable to pins 1
19. The cable is keyed to fit only one