Canon imagePRESS Server G200 Service Manual page 40

■ To reinstall and verify the imagePRESS Server
1. Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables in the imagePRESS Server make sure that:
• Covers are securely installed after routing cables.
• Cables are not looped around circuit boards or components (such as capacitors and resistors).
• Cable routing does not interfere with the operation of internal components.
• Cables do not lie on or against any internal heating element.
• Cables do not interfere with removing or replacing components.
• Cables do not interfere with opening or closing imagePRESS Server panels.
• Cables are not tangled.
• Cable slack is secured with a tie-wrap.
IMPORTANT:
Improper connection of the internal power cables can damage the imagePRESS Server. See
Server internal connections" on page
2. Replace the cover on the imagePRESS Server.
Make sure that all cables are fully inside the chassis before you replace the cover. Slide the cover until it engages the edge
of the chassis opposite the connector panel, and then lower the cover.
3. Replace the two screws that you removed earlier.
Tighten the screws to secure the cover to the imagePRESS Server.
4. Reinstall the imagePRESS Server on the side of the printer.
For detailed information about removing/installing the printer, see the installation instructions that accompany the printer (not
included in this service guide).
5. Connect the external cables that you removed during inspection or service.
Be sure to properly connect the following cables (see
page 11):
• Network cable
• Crossover Ethernet cable between the imagePRESS Server and printer
• Printer interface cable
• imagePRESS Server power cable
6. If you installed a new HDD, install system software (see
A spare HDD is shipped without preinstalled system software.
7. Make sure to configure the date and time in Setup (see Configuration and Setup, which is part of the user documentation
set).
8. Before you leave the customer site, verify the imagePRESS Server operation.
• Connect the imagePRESS Server to the network (see
14).
• Ask the site administrator to check the Setup options (see Configuration and Setup).
14, which includes "To check cable connections" on page
Replacing the chassis cover
"imagePRESS Server connector panel and LED diagnostic codes" on
"Installing System Software" on page
"Checking imagePRESS Server internal connections" on page
35
3. REPLACING PARTS
"Checking imagePRESS
14.
38).