Figure 76
1. Hairpin cotter
3.
Slide the hood to the right side, lift the other
side, and pull it out of the brackets.
Note:
Reverse this procedure to install the hood.
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Also,
lubricate the machine immediately after every
g031613
washing.
The grease-fitting locations and quantities are:
Traction Unit
•
2 brake pedal pivot-shaft bearings
•
2 front and rear-axle-pivot bushings
•
2 steering-cylinder-ball joints
•
2 tie-rod-ball joints
•
2 king-pin bushings
Note:
Lubricate only the top fitting on the king pin
annually (2 pumps).
62
(Figure
(Figure
(Figure
79)
(Figure
79)
(Figure
79).
Figure 77
Figure 78
77)
78)
g009246
g004687