Center Cutting Unit
Note:
You may need to raise the cutting unit to
expose the grease fittings for the latch pivot and the
lower link.
•
2 latch pivots
(Figure
Note:
You may need to manually trip the latches
to gain access to the grease fittings
Use a pry bar to close and open the latch.
•
2 caster-fork-shaft bushings
•
3 spindle-shaft bearings—located under the pulley
(Figure
83)
•
2 idler-arm-pivot bushings
Figure 79
81)
(Figure
(Figure
82)
(Figure
83)
1. Latch
g011499
80).
63
Figure 80
Figure 81
Figure 82
g009440
g009441
g011557