Protected Menus; Accessing Protected Menus - Toro 30608 30644 Operator's Manual

Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast

Protected Menus

Auto Idle
Mow Speed
Trans Speed
Smart Power
*Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced."
Titles will be in the selected language, but menu items
are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 4 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
auto idle time delay, maximum mowing ground speed,
maximum transport ground speed, and Smart Power.
These settings are in the Protected Menu.
Description
Controls the units used on the
InfoCenter; the menu choices
are English or Metric
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Controls the amount of time
allowed before idling the
engine when the machine is
not in use
Controls the maximum speed
while in mow (low range)
Controls the maximum speed
while in transport (high range)
Smart Power prevents
bogging down in heavy turf by
automatically controlling the
machine speed and optimizing
cutting performance.
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
Accessing Protected
Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit
(Figure 34B and
35
M , use the center button to
ENU
M and press the
ETTINGS ENU
33).
Figure 33
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 34A).
Figure 34
Figure 34C). Repeat this step
g028523
g028522