Product Overview; Controls - Toro 30608 30644 Operator's Manual

Product Overview

Controls

Note:
Determine the left and right sides of the
machine from the normal operating position.
Become familiar with all the controls before you start
the engine and operate the machine.
1. Brake pedal
2. Pedal-locking latch
3. Traction pedal
Traction Pedal
To stop the machine, reduce the amount of foot
pressure that you apply to the traction pedal until the
pedal returns to the N
EUTRAL
Brake Pedals
There are 2 foot pedals that operate individual wheel
brakes for turning assistance, parking, and to aid in
better side-hill traction. A latch connects the pedals
for parking-brake operation and transport
Pedal-Locking Latch
The pedal-locking latch connects the pedals together
to engage the parking brake
Tilt-Steering Lever
Press the tilt-steering lever down to tilt the steering
wheel to the desired position, then release the lever
to lock the adjustment
Figure 4
4. Parking brake
5. Tilt-steering lever
position (Figure
(Figure
(Figure 4).
(Figure 4).
Parking-Brake Latch
To engage the parking brake, connect the 2 pedals
together with the locking latch located behind the
pedal pads, and push down on the parking-brake latch
while you are pushing on the brake pedals
To release the parking brake, press the brake pedals
and the latch will disengage allowing the pedals to
come to the disengaged position. Ensure the pedals
have fully retracted after disengaging the parking
brake.
Key Switch
The key switch
O /P
N REHEAT
g203048
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
4).
Engine-Speed Switch
The engine-speed switch
change the engine speed. Tap the switch to increase
or decrease the engine speed in 100 rpm increments.
Hold down the switch to automatically move to High
or Low idle, depending on which end of the switch
4).
you press.
16
(Figure 5) has 3 positions: O
, and S .
TART
Figure 5
5. High-Low speed control
6. Engine-speed switch
7. Light switch (optional)
(Figure 5) has 2 modes to
(Figure 4).
,
FF
g028453