Toro 30608 30644 Operator's Manual page 52

5. The InfoCenter displays the I
R message
EGEN
6. The InfoCenter displays the time to complete
message (Figure
7. The engine computer checks the engine state
and fault information. The InfoCenter may
display the following messages found in the
table that follows:
Note:
If you attempt to do a forced parked
regeneration before 50 hours of the last
sucessful regeneration this message will appear.
If the machine is requesting a regeneration and
this message appears contact your authorized
Toro distributor for service.
Check Message and Corrective Action Table
Corrective Action: Exit the regeneration menu and run the
machine until the time since last regeneration is greater than
50 hours; refer to Time Since Last Regeneration (page
NITIATING
(Figure 65).
Figure 65
66).
Figure 66
DPF
Check Message and Corrective Action Table
(cont'd.)
g224411
Corrective Action: Troubleshoot the engine fault and retry
DPF regeneration.
g227681
Corrective Action: Start and run the engine.
Corrective Action: Run the engine to warm the coolant
temperature to 60°C (140°F).
g224406
g224406
Corrective Action: Change the engine speed to low idle.
Corrective Action: Troubleshoot the engine computer
condition and retry DPF regeneration.
8. The InfoCenter displays the home screen and
the regeneration acknowledge icon
appears in the lower right corner of the screen
as the regeneration processes.
45).
52
(Figure
Figure 67
67)
g224403