Pre-Maintenance Procedures; Raising The Seat; Lubrication; Greasing The Bearings - Toro 74760 Operator's Manual

Pre-Maintenance
Procedures

Raising the Seat

Make sure the motion-control levers are locked in the
P position. Lift the seat forward.
ARK
The following components can be accessed by raising
the seat:
•
Serial plate
•
Service decal
•
Seat adjustment bolts
•
Fuel filter
•
Battery and battery cables

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all
lubrication points.
Grease Type: No. 2 general-purpose lithium-based
grease
1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to the
P position, stop the engine, remove the
ARK
key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean the grease fittings
28) with a rag. Make sure to scrape any paint off
of the front of the fitting(s).
1. Front caster tire
Located on the seat pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check tire pressure every
25 operating hours.
4. Connect a grease gun to each fitting
and Figure 28). Pump grease into the fittings
until grease begins to ooze out of the bearings.
31
(Figure 27 and
Figure 27
Figure 28
3. Grease every 25 operating
hours.
4. Engine
(Figure 27
Figure
g014522
decal106-8717