Toro 30608 30644 Operator's Manual page 17

PTO Switch
The PTO switch has 2 positions: O
I ( ). Pull the PTO button out to engage the
N STOP
mower-deck blades. Push the button in to disengage
the mower-deck blades
High-Low Speed-Control Switch
The High-Low speed-control switch allows the speed
range to increase for transport of the machine
5).
Mower decks do not operate in high range. To switch
between the H and L
IGH
disengage the PTO and the cruise control, move the
traction pedal in the N
EUTRAL
machine move at a slow speed.
Lift Switches
The lift switches raise and lower the cutting units
(Figure 5). Press the switches forward to lower the
cutting units and rearward to raise the cutting units.
When starting the machine, with the cutting units in
the down position, press the lift switch down to allow
the cutting units to float and mow.
Note:
The cutting units do not lower while in the
high-speed range and they do not raise or lower if you
are out of the seat while the engine is running. Also,
the cutting units lower with the key in the O
and you are in the seat.
Cruise-Control Switch
The cruise-control switch locks in the pedal position
to maintain the desired ground speed
Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the
cruise-control function, and the front of the switch sets
the desired ground speed.
Note:
Pressing either brake pedal or moving the
traction pedal into the R
also disengages the pedal position.
( ) and
UT START
(Figure 5).
range, raise the decks,
OW
position, and have the
position
N
(Figure
position, for 1 second,
EVERSE
(Figure
1. Power-point port
Power-Point Port
Use the power-point port to power optional electrical
accessories
6).
17
Figure 6
2. Cruise-control switch
(Figure 6).
g028454