Drive System Maintenance; Checking The Seat Belt; Checking The Rollover Protection System (Rops) Knobs; Adjusting The Tracking - Toro Z Master Professional 6000 Series Operator's Manual

Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Visually inspect the seat belt for wear, cuts, and proper
operation of the retractor and the buckle. Replace before
operating if damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep the roll
bar in the fully raised locked position and use the
seat belt.
Ensure the seat is secured to the machine.
Check that both the mounting hardware and the knobs are in
good working condition. Make sure that the knobs are fully
engaged with the ROPS in the raised position. The upper
hoop of the roll bar may need to be pushed forward or pulled
rearward to get both knobs fully engaged (Figure 60).
1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area, and move the
motion-control levers to the neutral-locked position.
3. Move the throttle midway between Fast and Slow.
4. Move both motion-control levers forward until they
both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until the
machine tracks straight (Figure 61).
7. If it tracks to the left, loosen the bolts and adjust the
right stop plate rearward on the right T-slot until the
machine tracks straight (Figure 61).
8. Tighten the stop plate (Figure 61).
44
Figure 60
3. Roll bar in the upright
position
4. Roll bar in the folded
position