Mitsubishi Electric MELSEC iQ-F Series User Manual page 78

Refresh Settings
Set refresh parameters.
Double-click <Detailed Setting> of the "Refresh Settings".
Item
Link Side
CPU Side Target
Device Name
Points
Start
End
*1 If the remote stations are more than 16 units, since the number of device points of X and Y for the refresh target is short, assign the
devices to M, L, B and other devices.
*2 For device settings, refer to  MELSEC iQ-F FX5 User's Manual (Application).
7 PARAMETER SETTINGS
76
7.3 Basic Setting
Description
The number of points for the link devices (RX/RY, RWr/RWw) for the
number of occupied stations and start/end device number set in the network
configuration settings are displayed.
The target destination to be link refreshed is displayed.
Set the device of the link refresh target.
The number of device points for the link refresh target is displayed. (The
same value as the number of points on the link side is displayed.)
Set the start device number within the link refresh range.
The end device number within the link refresh range is displayed.
Setting range

Specify Device
(Default: Blank)
*1
X, Y, M, L, B, D, W, R
(Default: Blank)

Follow the device settings of the
*2
CPU parameters.
(Default: Blank)
