Storage; Storage Safety; Preparing The Traction Unit; Preparing The Engine - Toro Reelmaster 5510 Operator's Manual

Storage

Storage Safety

•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage and lower the cutting units.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
– Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.

Preparing the Traction Unit

1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Thoroughly clean the traction unit, cutting units,
and the engine.
3. Check the tire pressure; refer to
Tire Air Pressure (page
4. Check all fasteners for looseness; tighten them
as necessary.
5. Grease or oil all grease fittings and pivot points.
Wipe up any excess lubricant.
6. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
7. Service the battery and cables as follows; refer
to Servicing the 12 V Battery (page
A. Remove the battery terminals from the
battery posts.
B. Clean the battery, terminals, and posts with
a wire brush and baking-soda solution.
C. Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Toro Part
No. 505-47) or petroleum jelly to prevent
corrosion.
D. Slowly charge the battery every 60 days
for 24 hours to prevent lead sulfation of the
battery.
Checking the
58).
57):

Preparing the Engine

1. Drain the engine oil from the oil pan and install
the drain plug.
2. Remove and discard the oil filter. Install a new
oil filter.
3. Fill the engine with specified motor oil.
4. Start the engine and run it at idle speed for
approximately 2 minutes.
5. Shut off the engine and remove the key.
6. Flush the fuel tank with fresh, clean fuel.
7. Secure all the fuel-system fittings.
8. Thoroughly clean and service the air-cleaner
assembly.
9. Seal the air-cleaner inlet and the exhaust outlet
with weatherproof tape.
10. Check the antifreeze protection and add a
50/50 solution of water and ethylene glycol
antifreeze as needed for the expected minimum
temperature in your area.

Storing the Battery

If you are storing the machine for more than 30 days,
remove the battery and charge it fully. Store it either
on the shelf or on the machine. Leave the cables
disconnected if they are stored on the machine.
Store the battery in a cool atmosphere to avoid
quick deterioration of the charge in the battery. To
prevent the battery from freezing, ensure that it is
fully charged. The specific gravity of a fully charged
battery is 1.265 to 1.299.
70