Toro Reelmaster 5510 Operator's Manual page 12

Figure 9
1. Capscrew
2. Right tab (Carrier frame)
4. Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame
10) with the flange locknut (3/8 inch).
Figure 10
1. Flange locknut (3/8 inch)
2. Right tab (Carrier frame)
5. Align the studs of the left hose guide with
the holes in the cutting-unit frame and the
turf-compensator bracket
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
g375691
3. Flange locknut (3/8 inch)
(Figure
g375694
3. Capscrew
(Figure 11).
1. Turf-compensator bracket
2. Flange locknut (3/8 inch)
6. Assemble the hose guide and turf-compensator
bracket to the cutting-unit frame with the 2 flange
locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
Installing the Hose Guide
Cutting Units 5
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(Figure 12).
12
Figure 11
3. Stud (hose guide)
4. Inboard
Figure 12
5. Cutting unit 5
6. Reel motor
7. Weight
g375687
g375672