Chassis Maintenance; Inspecting The Seat Belt - Toro Reelmaster 5510 Operator's Manual

Figure 110
1. Backlap lever (mow
position—front cutting
units)
4. Lower and latch the operator's seat; refer to
Lowering the Seat (page
5. Wash all lapping compound off from the cutting
units.
6. For a better cutting edge, run a file across the
front face of the bedknife after lapping.
Note:
This removes any burrs or rough edges
that may have built up on the cutting edge.
g377117
2. Backlap lever (mow
position—rear cutting
units)
45).

Chassis Maintenance

Inspecting the Seat Belt

Service Interval: Before each use or daily
1. Inspect the seat belt for wear, cuts, and other
damage. Replace the seat belt(s) if any
component does not operate properly.
2. Clean the seat belt as necessary.
68