Toro Reelmaster 5510 Operator's Manual page 15

Figure 21
1. Turf-compensator bracket
2. Carriage bolt (3/8 x 1-1/4
inches)
6. Assemble the turf-compensator bracket to the
cutting-unit frame with the 2 carriage bolts (3/8 x
1-1/4 inches) and 2 flange locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
Installing the Kickstand
For each cutting unit, secure the kickstand to the
chain bracket with the snapper pin
Figure 22
1. Chain bracket
2. Snapper pin
g378789
3. Flange locknut (3/8 inch)
4. Inboard
(Figure 22).
g004144
3. Cutting-unit kickstand
Installing the Front Cutting Units
to the Lift Arms
1. Slide a cutting unit under the lift arm
1. Cap
2. Snapper pin
2. Assemble the pivot yoke onto the carrier frame
shaft.
3. Assemble the cap to the pivot yoke, and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the cap and the carrier-frame shaft to
the pivot yoke with the snapper pin.
5. Lock the cutting-unit pivot for cutting grass on a
hill side; refer to
for Cutting Grass on a Hill Side (page
Installing the Rear Cutting Units to
the Lift Arms
Cutting Units adjusted for a 1.2 cm (3/4 inch)
or Higher Height of Cut
1. Slide a cutting unit under the lift arm
15
(Figure
Figure 23
3. Pivot yoke
4. Carrier frame shaft
Locking the Cutting-Unit Pivot
17).
(Figure
23).
g375274
24).