Toro Reelmaster 5510 Operator's Manual page 11

1. Counterweight
Positioning the Turf Compensating
Spring and Installing the Hose
Guide
Cutting Units 4
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(Figure 7).
Figure 5
Figure 6
5. Cutting unit 5
6. Reel motor
7. Weight
g003320
1. Hairpin
2. Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame (Figure
g375671
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Turf-compensator bracket
3. Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit
Note:
Do not remove the flange serrated nut
from the capscrew.
11
Figure 7
8).
Figure 8
3. Flange locknut (3/8 inch)
(Figure 9).
g375689
g375690