Toro Reelmaster 5510 Operator's Manual page 20

Figure 36
1. Traction pedal
Throttle Control
Move the throttle-control lever
increase the engine speed and rearward to decrease
speed.
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the F
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
Cruise-Control Switch
The cruise-control switch has 3 positions: O
and E .
NGAGE
To turn on the cruise control, pivot the switch to the
middle position.
To engage the cruise control, briefly pivot the switch
forward. When cruise control is engaged, the cruise
control screen will appear on the InfoCenter. Use the
InfoCenter buttons to adjust the cruise control speed
in 0.8 km/h (0.5 mph) increments.
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal (Figure 36) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
2. Tilt steering pedal
(Figure 35) forward to
36) controls the forward and
position.
AST
FF
35) has 3 positions: O
.
Power-takeoff (PTO) Switch
When the PTO switch is engaged, the machine is in
M mode, which allows you to drive up to 13 km/h
OW
(8 mph) when the maximum speed is not limited.
When the PTO switch is not engaged
machine is in T
to drive up to 16 km/h (10 mph) when the maximum
speed is not limited.
Note:
Use the protected menus in the InfoCenter to
g383839
set the maximum speed for each mode.
1. Disengaged
Parking Brake
To engage the parking brake,
switch forward on the console. The red light on the
switch turns on when it is set. To release the parking
brake, pivot the switch backward.
Activating the parking-brake switch causes the traction
to automatically decelerate, regardless of traction
pedal position, and engage the parking brake as soon
, O ,
N
as the machine comes to a stop.
Once the engine has been shut off and the machine is
not moving, the parking brake engages, regardless of
parking-brake switch position.
Lower Mow/Raise Control Lever
This lever (Figure
units.
To lower the cutting units, push the lever forward.
When the PTO is engaged and the cutting units are
lowered, the cutting units start spinning. If the cutting
units are lowered before the PTO is engaged, the
cutting units will not start spinning.
InfoCenter
, The InfoCenter LCD display shows information about
FF
your machine, such as the operating status, various
20
mode, which allows you
RANSPORT
Figure 37
2. Engaged
(Figure
35) raises and lowers the cutting
(Figure 37), the
g424477
35) pivot the