Understanding The Acceleration Mode; Understanding The Warm-Up Mode - Toro Reelmaster 5510 Operator's Manual

•
When in transport range, press the reverse traction
pedal, engage the parking brake, or press the
cruise control switch to the O
•
When in mow range, press the reverse traction
pedal, engage the parking brake, disengage the
PTO, or press the cruise control switch to the O
positon.
Note:
Disengaging cruise control results in the
machine dynamically braking to a stop. If you
would like to disengage cruise control but continue
driving, press the traction pedal for a smooth
transition from cruise control to manual speed
control.
Figure 48
1. Cruise-control switch
Adjusting the Cruise Control
Speed
After the cruise control switch is enabled on the
console (Figure 48), use the InfoCenter to adjust the
speed setting of the cruise control
Figure 49
1. Indicates the cruise control
speed
2. Indicates the maximum
traction speed (pedal stop)
positon.
FF
g422430
(Figure 49).
g321767
3. This speed is locked out
under the protected PIN
menu.
Tips for Using the Cruise Control
•
Set a cruising speed for long distances without
many obstacles.
•
On rough terrain, use the InfoCenter to control
the speed.
FF
•
Use the cruise control for turnarounds as follows:
1. While mowing, set a safe, comfortable speed
for turning around at the end of mowing
passes.
2. Press the traction pedal to increase the
speed for mowing during the mowing pass.
3. Take your foot off the pedal when turning
around for the next mowing pass.
4. The machine will slow down to the low cruise
control setting, allowing you to make an
efficient turnaround at a constant speed.
5. After turning around, use the traction pedal
to increase the machine speed back up for
the next mowing pass.
Understanding the
Acceleration Mode
This feature determines how quickly the machine
changes traction speed when the traction pedal is not
in the N position.
EUTRAL
Note:
If you take your foot off the traction pedal,
allowing it to return to the N
machine is moving, the braking profile is engaged.
The braking profile is always the same and cannot be
customized by the acceleration mode feature.
Enter the protected menus in the InfoCenter to change
the acceleration mode. The acceleration mode has
the following 3 positions:
•
Low—least aggressive acceleration and
deceleration
•
Medium (default)—medium acceleration and
deceleration
•
High—most aggressive acceleration and
deceleration
Understanding the
Warm-Up Mode
When starting the machine in cold weather, a
message and a A snowflake icon
33
position while the
EUTRAL
appear on the