ABB ACS560 Quick Installation And Start-Up Manual page 17

Note: The bare shield is grounded 360°. Mark the pigtail made from the shield as
a PE conductor with yellow-and-green color.
PE
PE
5. Connect the input power cable as follows:
• Ground the shield 360° by tightening the clamp of the power cable grounding
shelf onto the stripped part of the cable (6a).
• Connect the twisted shield of the cable to the grounding terminal (6b).
• Connect the phase conductors of the cable to the terminals of L1, L2 and L3.
• Tighten the screws to the torque given below.
Frame size
L1, L2, L3
6. Connect cable by the motor cable method mentioned in step 3.
7. Ground the shield 360° (7a).
EN - Quick installation and start-up guide 17
N·m
2.5...4.5
6c
6b
6a
R3
lbf·ft N·m
1.8...3.3 4.0
EN
HI
R4
lbf·ft
3.0