Huawei AP4030DN Hardware Installation And Maintenance Manual page 97

Huawei AP4030DN
Hardware Installation and Maintenance Guide
Content
n
MN(BC)-B-BGN
D
MN(BC)-B-PGN
D
The label only carries location information about the destination direction of the power cable
while information of the local end is not necessary. That is, the label only carries location
information about the opposite equipment, the control cabinet, or the distribution box.
5-26
DC voltages, such as 24 V and 60 V should be given in similar methods.
Make sure that labels are affixed in the correction direction. That is, after the cable ties are
bundled onto the cable, the identification plates with the labels should face up, and the text on
the labels in the same cabinet should be in the same direction. For details, see
Figure 5-93 Example of the labels for DC power cables
The meaning of the label in


In the power distribution box or the first power cabinet of a row in a transmission equipment room,
every terminal block on the -48 V connector bar has a numeric identification. For example, in the above
label of "A01/B08--48V2", "08" (or sometimes "8") is the numeric identification of the terminal block.
Issue 02 (2015-05-18)
Meaning
B: chassis number, numbered in the bottom-up order with two digits,
for example, 01.
N: power socket number, numbered as 1 to 3 in the bottom-up and
left-to-right orders.
On the loaded cabinet side, only MN is used to identify the cabinet.
On the power cabinet side, MN identifies the row and column number
of the power distribution equipment like a control cabinet and
distribution box, and BC identifies the row and column number of the
-48 V connector. If there is no row number or column number, or the
connector can be identified without them, BC can be omitted. It is
unnecessary for BGND and PGND to identify the row and column
number.
lists the information on two -48 V power supplies on the label. The information on other
Figure 5-93
On the loaded cabinet side, the label "A01/B08--48V2" on the cable indicates that the
cable is -48 V DC supply, which is from the eighth connector on row B of -48 V bus bar
in the cabinet on row A, and column 1 in the equipment room.
On the distribution box side, the label "B03--48V2" indicates that the cable is -48 V DC
supply, connected to DC power socket 2 on row B, column 03 in the equipment room.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
is as follows:
5 Appendix
Table
Figure 5-93.
93