Table of Contents
Advertisement
Huawei AP4030DN
Hardware Installation and Maintenance Guide
Figure 5-18 Fitting the metal shell onto the twisted-pair cable
Step 4 Fit the metal shell onto the twisted-pair cable until the shield layer is covered completely.
Along the edge of the metal shell, cut off the aluminum foil shield layer and ensure that there
is no surplus copper wire. The exposed twisted-pair cable is about 20 mm (0.79 in.) long, as
shown in
Figure 5-19 Removing the shield layer of a twisted-pair cable (unit: mm (in.))
Step 5 Based on the colors, lead the four pairs of twisted-pair wires through the wire holder, as
shown in
Figure 5-20 Leading wires through the wire holder
Issue 02 (2015-05-18)
Figure
5-19.
Figure 5-20
and
Figure
C
G
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-21.
5 Appendix
35
Advertisement
Table of Contents
