Huawei AP4030DN Hardware Installation And Maintenance Manual page 55

Huawei AP4030DN
Hardware Installation and Maintenance Guide
Figure 5-47 Crossing two terminals
If the two terminals are different in size, place the smaller one above the bigger one. A
maximum of two terminals can be installed on a post.

----End
Installing the Cord End Terminal
Procedure
Step 1 Hold a cord end terminal upright and place it on a terminal jack, as shown in
ensure bump contact and dense connection, place the plain side of the terminal outwards.
Figure 5-48 Placing a terminal on a terminal jack vertically
Step 2 Insert the terminal into the jack vertically, and fasten the terminal by turning the matching
screw in the clockwise direction, as shown in
Issue 02 (2015-05-18)
To remove an OT terminal, loosen the screw in the counterclockwise direction.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-49.
5 Appendix
Figure 5-48. To
51