Panasonic LP-GS Series Operation Manual page 239

‒ GS1 DataBar Limited CC-A, GS1 DataBar Stacked CC-A: Specifies the laser power
• "Scan speed correction [%]":
To correct the scan speed, enter a value in the text box.
‒ GS1 DataBar Limited CC-A, GS1 DataBar Stacked CC-A: Specifies the scan speed
• "Pulse cycle correction [%]" (LP-RF, LP-RV):
To correct the pulse cycle, enter a value in the text box.
‒ Point radiation objects: The pulse cycle of all points in the selected object is adjusted.
‒ GS1 DataBar Limited CC-A, GS1 DataBar Stacked CC-A: Specifies the pulse cycle
GS1 DataBar Limited CC-A, GS1 DataBar Stacked CC-A: Under "Laser correction (2D)",
specify laser correction parameters for the 2D part of the code and the separator between
the 1D and 2D part.
• For the 2D part of the code, you can specify values for "Laser power correction [%]",
"Scan speed correction [%]" and "Pulse cycle correction [%]" (LP-RF, LP-RV).
• For the separator, you can set values for "Laser power correction (separator) [%]", "Scan
speed correction (separator) [%]" and "Pulse cycle correction (separator) [%]" (LP-RF, LP-
RV).
Note
• Marking is not possible if the laser power correction value is 0.
• If the corrected value exceeds the allowable limit, the marking is performed with the
maximum or minimum parameter value. The correction ratio is calculated based on the
value set as 100% in "Laser settings".
• For bar code or 2D code objects, you can fine-tune the time until the laser starts radiating
at the start or end point in "Laser settings" under "Customize starting/ending point by
object".
Related topics
Set laser correction parameters for code elements
Set laser parameters
Fine-tune the laser settings
ME-NAVIS2-OP-1
"Laser power correction [%]" for one point: The laser power is set by multiplying the
laser power correction ratio set for the point and the laser power value set in "Laser
settings".
for the 1D part of the code.
for the 1D part of the code.
for the 1D part of the code.
(page 230)
(page 231)
(page 178)
22 Laser settings
239