Yamaha AW2816 Owner's Manual page 87

6
Move the cursor to the RTN. area, and use
the [DATA/JOG] dial to select the input jack
or input channel that you want to assign as
the insert return.
The following types of jack can be selected.
• If an input channel 1–8 or a monitor channel 1–
16 is selected
Display
AD 1–AD 8 INPUT jacks 1–8
INPUT 1–8 of an I/O card
SLT 1–SLT 8
(OPTION I/O slot)
D STIN L/D STIN L or R channel of the DIGITAL
R STEREO OUT jack
• If return channel 1/2 or the stereo output chan-
nel is selected
Display
AD 1/2–AD 7/8 INPUT jacks 1/2–7/8
Input channels 1/2–7/8 of the
SLT 1/2–SLT 7/8
OPTION I/O slot
DSTI L/R DIGITAL STEREO IN jacks (L/R)
7
When you have finished making patching
settings, move the cursor to the OK button
and press the [ENTER] key.
The EFFECT INSERT area will indicate "ON
(EXTERNAL)," and the input/output jacks/input/
output channels will be assigned to the insert I/O
point.
For example if you have selected "OMNI 1" as
the insert send of the monitor channel 1, and
selected "AD 1" as the insert return, the signal
flow will be as follows.
External effect
INPUT
OMNI OUT jack 1
INPUT
ATT Ø
PATCH
Monitor channel 1
Content
Content
OUTPUT
INPUT jack 1
EQ DYN
Operation section
In this state if you access the PATCH screen Patch
OUT page, the OMNI OUT ASSIGN 1 area will
indicate "I-M 1." This indication means that the
insert send of monitor channel 1 has been
assigned to OMNI OUT jack 1.
If you change the "I-M 1" setting, the insert I/O
point patching will be defeated. If you do so, be
aware that you will need to make the settings
once again, starting with step 1.
Tip!
• External effects can be patched for multiple chan-
nels. However, it is not possible for multiple insert
sends to use the same output jack or output channel.
• If you want to save the insert I/O patching settings
you make here, store the current state as a scene
memory. Insert I/O point information cannot be
stored in a patch library or channel library.
4
79