Yamaha AW2816 Owner's Manual page 268

UTILITY screen
Make overall settings for the AW2816 (2)
Function
Set the rollback time, pre-roll/post-roll
time, and the nudge playback method
etc.
Key operation
• [UTILITY] key [F3] (Prefer.2) key
• Repeatedly press the [UTILITY] key
until the screen shown at the right
appears.
Screen functions
A
GRID
This sets the minimum unit when you specify an
area in the EDIT screen TR Edit page or V.TR Edit
page. For example if the grid value is set to
"00:00:00.010," the specified location will
move in 10 millisecond increments for each
click of the [DATA/JOG] dial. (Default=
00:00:00.000)
• If measure units are selected as the counter display
method, the GRID setting will be ignored.
• The GRID setting has no effect on adjustment of the
locate points (TRACK screen/Mark Adj. page) or on
using the [NUM LOCATE] key to specify the locate
points.
B
ROLLBACK TIME
This specifies the time of the rewind that will
occur when the [ROLL BACK] key is pressed. You
can set this time in 1 millisecond increments over
a range of 0–30 seconds (default setting= 5 sec-
onds). For details on using Rollback, refer to page
98.
C
PREROLL/POSTROLL TIME
These settings specify the pre-roll time (the play-
back time that precedes punch-in) and post-roll
time (the playback time that follows punch-in).
Each can be set in 1 second increments over a
range of 0–5 seconds (default setting= 5 seconds).
For details on using auto punch-in/out, refer to
page 64.
266
Prefer. 2 page
1
2
3
4
D
METER FINE
This selects the resolution of the level meters dis-
played in the METER screen Meter1/Meter2 page.
Move the cursor to the button and press the
[ENTER] key to switch between the following two
settings.
• NORMAL
The full range of the level meter will correspond to
values of –48 dB to 0 dB.
• FINE
The full range of the level meter will correspond to
values of –18 dB–0 dB. This setting is convenient
when you want to perform detailed level adjust-
ments near 0 dB.
Tip!
• This setting does not affect the level meters displayed
in pages other than the METER screen.
• The level meter resolution can also be selected in the
METER screen Meter1/Meter2 page.
E
PLAY MODE
This selects the play mode of the Nudge function
(a function that lets you use the [JOG ON] key and
the [DATA/JOG] dial to search for a location).
Move the cursor to this button and press the
[ENTER] key to switch between the following two
settings.
• AFTER
Playback will be repeated for the specified nudge
time (6) starting at the current location.
• BEFORE
Playback will be repeated for the specified nudge
time (6) ending at the current location.
Reference section
5
6
7
8